ProLights REFLEXs, Руководство пользователя

Страница: 39 / 48

17
REFLEXs
3.17 FIXTURE INFORMATION
• Press the MENU button until the display shows one of the following, and then press the ENTER button.
• Set the desired parameter using the UP/DOWN button and press the ENTER button to confirm the set-
ting.
- Firmware Version - Select Firmware Version , press ENTER button to confirm, firmware version will show on
the display, press MENU button back to exit.
- Temp. - Through the function temp. can be displayed on the display the temperature of the device in
° C. When the temperature is under 60°C, the fixture will work normally; when it’s between 65°C and
75°C, the fixture will reduce the power output; when it reach 75°C or higher, the LED display will be
OFF.
-
Fixture Time
- Through the
Fixture Time
function you can display the operating time of the projector.
3.18 DELAY FUNCTION
• Press the MENU button and select through directional buttons the Function Delay menu voice, then press
the ENTER button. Use DOWN and UP button to select the
No Delay, 1 s Delay, 2 s Delay, 3 s Delay
mode and
press ENTER button for save setting. For to go back to the main menù without any change press the
MENU button again.
3.19 BLACK OUT FUNCTION
• From the home menu, press the MENU button until the display reads Black Out , then press the ENTER
button. Select Yes for send the device in standby mode, or select No for not change the operation of the
device, then press the ENTER button.
NOTE - When Black Out all the functions of the device, except for White Balance and those of the test and re-
set functions described in paragraphs 3.15 and 3.16 will no longer be usable. It may also be used via DMX
control from a DMX controller.