ProLights REFLEXs, Руководство пользователя

Страница: 34 / 48

REFLEXs
12
Number of
DMX channels
Start address
(example)
DMX Address
occupied
Next possible start
address for unit No. 1
Next possible start
address for unit No. 2
Next possible start
address for unit No. 3
15 33 33-47 48 63 78
3.8 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3/5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.9 DMX MODE
For operation via light control unit with DMX512 protocol, is sufficient connect the controller to REFLEXs.
The projector has a 14 channels DMX configuration. For the values of it see tables on page 14.
• To set the DMX address, press the button MENU so many times until shows DMX Address, then press the
button ENTER to confirm.
• Press the button UP/DOWN to select the desider value (001 - 512).
• After the setting value is automatically saved.
3.10 DMX ADDRESSING
For operation via light control unit with DMX512 protocol, is sufficient connect the controller to REFLEXs.
The tables on page 14 indicate the operating mode and DMX value. The REFLEXs is equipped with 3/5-
pole XLR connections. To able to operate the REFLEXs with a light controller, adjust the DMX start address
for the first a DMX channel. If e. g. address 33 on the controller is provided for controlling the function of
the first DMX channel, adjust the start address 33 on the REFLEXs. The other functions of the light effect
panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Example 15 DMX channels configuration
DMX512 Controller
. . . . . . . . . . . .
DMX Address: 33 DMX Address: 78 DMX Address: 48 DMX Address: 63
Fig.5