PANORAMA IP AIRBEAM
12
3.8 ETHERNET
To enable Ar-tnet mode, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select
Connect
, then press the ENTER button to enter the
next menu.
• Press the UP/DOWN button to scroll through the menu, select
Ethernet
and press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select
DMX Out, IP Address, IP Mask, Universe
and
press ENTER to activate the mode.
• Press the LEFT button repeatedly to exit the menu and save changes.
3.9 ID AND RDM
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for “Remote Device Management” and makes remote control of
devices connected to the DMX-bus possible. Manual settings like adjusting the DMX starting address are
no longer needed. This is especially useful when the device is installed in a remote area. RDM is integrated
in DMX without influencing the connections. The RDM-data is transmitted via the standard XLR-poles 1
and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX devices can be operated
in one DMX line. The RDM protocol sends own packages in the DMX512 data feed and does not influence
conventional devices. If DMX splitters are used and RDM control is to be used, these splitters must sup-
port RDM. The number and type of RDM parameters depend on the RDM controller (not included) is used.
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select
Connect
, then press the ENTER button to enter the
next menu.
• Press the UP/DOWN button to scroll through the menu, and then select the
Fixture ID
and press the
ENTER button to enter the next menu.
• Press UP/DOWN button to scroll through the menu, then select
Password
and press ENTER to confirm.
• Use the arrow keys to enter the password
050
and press ENTER to confirm.
• Once you have entered your password, you can set the
PID Code
, necessary to control the unit with the
RDM protocol. Press the UP/DOWN button to scroll through the menu, select PID Code and press EN-
TER to confirm.
• Use the arrow keys to enter the PID Code, then press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
3.10 DMX ADDRESSING
For operation via light control unit with DMX512 protocol, is sufficient connect the controller to PANORA-
MAIPAB. To able to operate the PANORAMAIPAB with a light controller, adjust the DMX start address for the
first a DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first
DMX channel, adjust the start address 33 on the PANORAMAIPAB. The other functions of the light effect
panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Содержание PANORAMA IP AIRBEAM
