ProLights LUMIPAR7QTOUR, Руководство пользователя

Страница: 30 / 44

LUMipAR7QTOUR
10
3.4 AUTO SHOW
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows
Auto Show
, then press the button ENTER.
• Press the button UP/DOWN to switch between the show ( Auto 1 - 5 ). The unit will operate in show mode.
• Using the button UP/DOWN to select the desired run speed slow-fast (0-100) .
• Press the button ENTER to save the setting.
IMPORTANT: Programs
Auto 1 - 5
are fully pre-programmed and will not be altered by changes. Instead,
Manual Color mode allows to combine the colors Red - Green - Blue - White .
• Press the button MENU so many times until the display shows Static , then press the button ENTER.
• Through the button UP/DOWN select Manual Color , then press the button ENTER.
• Select the color Red - Green - Blue - White through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Set the value (000 - 255) , through the buttons UP/DOWN.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.5 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• To enable the static mode, press MENU repeatedly until Static shows on the display.
• Press the button ENTER.
• Through the button UP/DOWN select
Fixture Color
, then press the button ENTER.
• Select the desired preset color (R - G - B - W - GB - RB - RG - RGB - RW - GW - BW - RGW - RBW - GBW - RGBW) using the
button UP/DOWN.
• Press the button ENTER to save the setting.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
6
DMX Address
ð
1 - 512
7 DMX Channel
ð
4 Ch
6 Ch
10 Ch
8
Master/Slave
ð
Master
Slave
9 White Balance
ð
R
ð
Value (125-255)
G
ð
Value (125-255)
B
ð
Value (125-255)
10 LED Frequency
ð
600Hz - 25kHz
11 Temperature
ð
36°C