PROLIGHTS - EclNanoPanel
TWC
13
• The transmitter scans for all unlinked receivers for a period of about 5 seconds.
• If the connection fails, check the position of the receiver.
• The wireless icon on the receiver display indicates the received signal strength.
Unlinking the transmitter
Follow the procedure below to unlink the transmitter from all receivers connected with the unit.
1.
Push MENU button untill you show CONNECT on display, then press ENTER button to confirm.
2.
Use UP/DOWN buttons for select Wireless, then press ENTER to confirm.
3.
Enable TX UNLINK to ON 8 (please note that TX UNLINK will be avaible only if WDMX mode is set
to Transmitter).
• All connected receivers will be unlinked.
DMX TO WDMX (TX)
This function enable or disable the transmission throught wireless of the DMX signal from the transmit-
ter side to the receiver.
OPERATION AS A WIRELESS RECEIVER
ECLNANOPANELTWC can be used as wireless receiver connected to a wireless transmitter.
To use ECLNANOPANELTWC as wireless receiver, please follow the procedure below:
1.
Push MENU button untill you show CONNECT on display, then press ENTER button to confirm.
2.
Use UP/DOWN buttons for select Wireless, then press ENTER to confirm.
3.
Push ENTER button on WDMX ON/OFF function and enable it to ON.
4.
Select WDMX mode and set it on Receiver (please note that WDMX mode will be available only if
WDMX ON/OFF is set to ON).
5. Enable RX RESET to ON to reset the receiver (please note that RX RESET will be avaible only if
WDMX mode is set to Receiver).
6. On the transmitter, enable TX LINK to ON to link transmitter to the receivers.
7.
If the connection is successful and DMX input is available the display the display on the receiver
unit will shows the DMX address. If DMX signal is not available, the display will shows "No signal"
but keeps the transmitter linked.
8. If the connection fails, check the position of the receiver.
9. The wireless icon on the receiver display indicates the received signal strength.
Reset the receiver
Follow the procedure below to reset the receiver.
1.
Push MENU button untill you show CONNECT on display, then press ENTER button to confirm.
2.
Use UP/DOWN buttons for select Wireless, then press ENTER to confirm.
3. Enable RX RESET to ON.
• The wireless icon on the receiver display indicates the received signal strength.
WDMX TO DMX (RX)
This function enable or disable the retransmission of the wireless DMX signal received throught the
DMX port on the receiver side.