Prolife PA2 BT, Инструкция по эксплуатации

Страница: 13 / 76

13
en
The device gives an
error message sever-
al times in succession
or the measurement
values do not corre-
spond to subjective
general condition
(too high / low)
Check the positioning of the cuff
Measure the blood pressure again in peace and quiet under
observance of the details following the requirements out-
lined in the “ Measurement procedure ” section
The results of several
consecutive meas-
urements vary sig-
nificantly
Please read and understand "The most common causes
of errors" section. Repeat the measurement again, making
sure all the rules for its execution are followed.
NOTE: The blood pressure is a dynamic value and fluc -
tuates continually, therefore, a minor difference in val -
ues is acceptable between consecutive measurements
Blood pressure
measured differs
from those values
measured by the
doctor
Keep a self–monitoring diary and show it to your doctor at
the next visit.
NOTE: A patient may experience "white coat syndrome"
at the doctor’s appointment, so the pressure readings
are higher than in a familiar home environment
Additional information
•
The level of blood pressure is subject to fluctuations even with healthy
people. Important thereby is, that comparable measurements always
require the same conditions (Quiet conditions)! If, in spite of observ-
ing all these factors, the fluctuations are larger than 15 mmHg, and / or
you hear irregular pulse tones on several occasions, please consult your
doctor. The manufacture of the devices takes place according to the
terms of the European standard for blood pressure measuring devices
(see technical data).
•
Never attempt to repair the device yourself.
•
If you have questions related to the operation of the device and possi-
ble malfunctions, please contact the official representative of the manu-
facturer or the service center. Any manipulations with the device
(opening, mechanical or any other damage) will void all warranty claims.