Programma EGIL BM-19070, Руководство пользователя

Страница: 67 / 80

P r o g r a m m a E l e c t r i c A B
Z P - B M 0 1 D R 0 7 A
6 7
E G I L
11.2 Voltage
measurement
(Motion channel)
Confirm that you want to continue with the calibration of
the voltage scale.
Adjust Voltage
<Yes> No
Note! This action changes the scale factor and
must be done by qualified personnel
only.
Egil as a Volt meter
1. Connect a stabilized voltage source with a
calibrated volt meter in parallel to the
motion input, pin 1 and 3.
2. Adjust the voltage in the motion circuit to
about 4 V. Note: If too low or too high
voltage is applied, the display will indicate
“out of range!”.
Test Voltage
xx V
3. Press ENTER to continue.
Loading the precise voltage
value
1. Enter the correct value of the voltage used
during the calibration procedure red out
from the volt meter.
Source Voltage
xx V
2. Press ENTER to finish the calibration
process.
Note! During the calibration most of the keys
and knobs are disabled.
Egil as a timer
1. Connect the start input of a calibrated
frequency counter to the close coil input/
output of Egil.
2. Connect the stop input of the frequency
counter to the open coil input/output of
Egil.
3. Set the delay time of open to 500 ms.
4. Select a C-O operation.
5. Connect timing channels L1/L2/L3 to the
open input/output.
6. Turn the MEASURE knob.
7. Compare the timing result of Egil with the
result of the frequency counter.
Note! This is a verification of the timing accu-
racy. There are no possibilities of adjust-
ments.