Programma EGIL BM-19070, Руководство пользователя

Страница: 29 / 80

P r o g r a m m a E l e c t r i c A B
Z P - B M 0 1 D R 0 7 A
2 9
E G I L
6.3 Menu tree for the
SEQUENCE menu
Below, is a diagram of the SEQUENCE menu. The pulse
lengths and delay times in the example below are taken
from the default settings.
O
0.20s C:0.30s
Pulse Delay
O:0.10s
Cls Pulse Length
0.10s
Opn Pulse Length
0.10s 0.29s
Next Sequence
OC OCO
C:0.00s
Pulse Delay
O:0.01s
Cls Pulse Length
0.29s
Opn Pulse Length
0.29s
0.00s
Opn Pulse Length
0.00s
Cls Pulse Length
0.30s
Next Sequence
C CO
C:0.00s
Pulse Delay
O:0.01s
Cls Pulse Length
0.10s
Opn Pulse Length
0.29s 0.00s
6.4 The MAIN menu
From the main menu, you can set general parameters, print
settings, save and retrieve settings and calibrate the
instrument. If you have an Egil with the motion channel
option, you can also choose analog channel, open speed
and close speed settings. To access the main menu, press
the SEQ/MENU button.
You can choose between the following menu headings.
Menu heading Function
Setup General parameters and options
Print Print parameters
Save Save configuration in memory
blocks
Recall Recall configuration from memory
Calibration Calibration of current/voltage
measurements and motion
channel
Option - >
Analog Channel Settings for motion channel
Open Speed Speed calculation points
Close Speed Speed calculation points
Option - End
Display Show data/time on the display
Monitor Show on-line measurement
values
Setup
Here you set general parameters and options for:
Measure Time
Here you can choose between the measure times 1, 2, 5,
10, 20, 50 and 100 seconds. At 1 s, the time resolution is
0.1 ms and at 100 s, the resolution is 10 ms. You choose
the unit for measure time in the TIME BASE section.
Note! If you change the measure time, the
measurements most recently taken are
erased.
Language
Here you choose between English, German, French,
Spanish or Swedish. If you select another language than
English and want Egil to “remember” this next time you
start the instrument you must save the setting in memory
“0”.