HANGING THE HEATER
1) Lift the heater up and into the mounting bracket.
2) Align the bracket screws with the keyhole slots in the mounting bracket.
3) If the heater is to be tilted, it must be positioned in the keyhole slots - see figure 6.
4) Tighten the bracket screws with a wrench to secure the unit once suspended
at horizontal or vertical level.
Keyholes
USE BOTTOM
KEYHOLE SLOTS
IF HEATER IS TO
BE TILTED DOWN
Bracket Screws
Figure 6
REMOVE SCREW TO OPEN COVER
ADJUSTING AIR FLOW DIRECTION
1.
To turn the unit horizontally when it has been installed with a single lag bolt (as
shown in figure 5a), simply turn the entire heater as needed. (as shown in figure 7 –
rotate). The unit cannot be turned horizontally if it has been installed with 2 lag
bolts.
2.
To tilt the unit vertically, loosen the bracket screws (see figure 6) and see figure 8 to
view multiple vertical angles.
3.
Adjust louvers to the desired position.
NOTE: The louvers are designed so they cannot be completely closed. Do not attempt to
defeat this feature; damage to the unit can result.
NOTE
:
To prevent possible overheating, please maintain adequate clearance as shown in
figure
3.
Figure 7
