Connection of power cables
:
1. Remove the screw from the front of the unit to connect the power to the heater.
2. Attach the cable connectors to the unit (See Figure 13) and slide the
8
-gauge wire
through the cable connector.
3. Connect the wire to the power block located in the base of the heater - See Figure 14.
4. Turn on the power at the main service panel.
NOTE: All wiring must be carried out by a certified electrician and comply with national and
local electrical codes in the Canada & United States. For certain applications, conduit may
be required. Check local electrical codes. If you run the wiring in conduit and wish to be able
to turn the heater, be sure to purchase enough flexible conduits to allow the heater to be
turned.
Figure 13
Figure 14
