10
DIAGRAM OF THE CONSOLE
Clip
Key
Speed Control
Monitor Displays
LED Track
STEP BY STEP CONSOLE OPERATION
Step onto the foot rails of the treadmill. Find the clip
attached to the key (see the drawing above), and slide
the clip onto the waistband of your clothing. Follow the
steps below and on page 11 to operate the console.
Insert the key fully into the power switch.
When the key is in-
serted, the first indicator
in the LED track will
light. The four displays
will not turn on until the
ON/RESET button is
pressed or the walking
belt is started. Note: If you just installed batteries,
the displays will already be on.
Reset the speed control.
Slide the speed control
down to the RESET
position. Note: Each
time the walking belt
is stopped, the
speed control must
be moved to the
RESET position be-
fore the walking belt
can be restarted.
Start the walking belt.
After you have moved the speed control to the
RESET position, slide it slowly upward until the
walking belt begins to move at slow speed.
Carefully begin walking on the walking belt.
Change the speed of the walking belt as desired
by sliding the speed control. To stop the walking
belt, step onto the foot rails and slide the speed
control to the RESET position.
Change the incline of the treadmill, if desired.
To increase or decrease the
incline, hold down the top or
bottom of the incline button.
Important: Do not change
the incline of the treadmill
by placing objects under
the treadmill. Change the
incline only as described
above.
Important: Before folding the treadmill, adjust
the incline to the lowest position.
1
Note: If there is a thin sheet of clear
plastic on the console, remove it.
2
3
4
