6
3
2
31
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
41
20
43
1
42
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (42) to
the Lower Wire Harness (43). Gently pull the upper
end of the Upper Wire Harness to remove any slack
from the Wire Harnesses.
Turn the indicated Adjustment Knob (20) counterclock-
wise two or three turns to loosen it. Next, pull the
Knob, insert the Upright (2) into the Frame (1), and
then release the Knob. Be careful to avoid pinching
the Wire Harnesses (42, 43). Move the Upright up
and down slightly until the pin on the Knob snaps
into one of the holes in the Upright. Then, turn the
Knob clockwise until it is tight.
Attach the Water Bottle Holder (31) to the Upright (2)
with two M4 x 12mm Screws (41).
4. Loosen the eight indicated screws (A) in the
Handlebar (3).
Attach the Handlebar (3) to the Upright (2) with eight
M6 x 16mm Tapered Button Screws (59). Do not
tighten the Tapered Button Screws yet.
Retighten the eight screws (A) in the Handlebar (3).
3
A
A
4
59
59
2
5. Remove the six M4 x 16mm Screws (57) and the Left
and Right Handlebar Covers (5, 6) from the Console
(4).
4
5
6
57
57
57
