5
1. Identify the Front Stabiliser (3), which has Wheels (32)
attached to it. Whilst another person lifts the front of
the Frame (1), attach the Front Stabiliser to the Frame
with two M10 x 112mm Carriage Bolts (34) and two
M10 Nylon Locknuts (29).
Make sure that the Front
Stabiliser is turned so the Wheels are not touching
the floor.
3
29
32
32
34
1
1
2. Whilst another person lifts the back of the Frame (1),
attach the Rear Stabiliser (4) to the Frame with two
M10 x 112mm Carriage Bolts (34) and two M10 Nylon
Locknuts (29).
34
4
1
3
2
86
87
1
63
83
70
96
71
3. Whilst another person holds the Upright (2) in the
position shown, connect the Upper Wire Harness (86)
to the Lower Wire Harness (87).
Carefully pull the
upper end of the Upper Wire Harness to remove
any slack. Whilst holding the upper end of the
Upper Wire Harness,
insert the Upright into the
Frame (1).
Do not pinch the Wire Harnesses.
Slide an M10 Split Washer (70) and a Frame Spacer
(83) onto the M10 x 88mm Button Screw (63), and
insert the Button Screw into the Frame and the
Upright.
Make sure that the concave end of the
Frame Spacer is turned toward the Frame. Do not
tighten the Button Screw at this time.
Attach the Water Bottle Holder (71) to the Upright (2)
with two M4 x 22mm Screws (96).
2
29
29
Make sure the
Wire Harnesses
(86, 87) do not
get pinched and
damaged during
this step.
4. The Console (5) requires four 1.5V “D” batteries; alka-
line batteries are recommended. Remove the indicated
screw from the battery drawer, and pull the battery
drawer open. Insert four batteries into the battery
drawer;
make sure that the batteries are oriented
as shown by the markings inside of the battery
drawer.
Close the battery drawer and reattach the
screw. Note: When the batteries are installed correctly,
the fan will turn on for a moment.
5
Battery
Drawer
4
Batteries
Screw
