User Guide
DVS-21
02/2018
• V.1.0 • L. Wolle
14/131
© 2017 ProCom
®
Professional Communication & Service GmbH • Technical changes reserved.
Userbank List
Each CPU can store 4 different programs. An icon of this program is displayed in the list. The timestamp
is set at the time of the storage event, based on the system time of the system. The
Tick
in the checkbox
marks the
active program
, which the system is running. This is not to be confused with the
Marking of a
line
for a desired
Action
. Reading and writing is possible at any time without any adverse effect on the
running system.
The display of the DVS version shows the firmware version of the system for information purposes.
User bank request
Updates the status list of the 4 user banks by a fresh reading of the status list
Change user bank
To activate another program, the desired line in the list must be marked. The
Change user bank
switch executes the command. The system reboots automatically
and now runs the new program. A
Change user bank
to the active bank initiates a
restart.
Read system data
Loads the program from the user bank of which the line is marked. This can also
involve the active program. The read out depends on whether a program has
already been opened for configuration in the
System data
component. If no program
is open, then on completion of transfer, the program that has been read is
transferred to the
System data
component automatically. Otherwise, the read
program is parked. It can be saved immediately by means of the
Save as
button.
Write system data
opens the file selection dialog and transfers the selected program file to the user
bank, which has its line marked. This cannot involve the active program. Writing
takes place irrespective of whether a program is open for configuration in the
System data
component.
Important!
It is not possible to transfer the configuration opened for editing directly
to the system. A path via a stored file is always required.
Save as
Stores a read and parked program in a file.
Edit
Opens a read and parked program for configuration in the
System data
component.
A read program is parked until it is read or written once more. At this time it is always possible to apply
the data for configuration by using
Edit
.
Connection via modem
The button is used to connect to a dial-up / dedicated line via a modem connected to a PC/Notebook. The
required settings are described under
System program
. Once a connection
to the system via the modem has been established successfully, all the described functions are also
available.
