ShockWave
®
26
5
EN
Transmitter Controls
Installing Transmitter Batteries
CAUTION:
If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons
and/or damage to property.
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
CAUTION:
Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to
national regulations.
2.4GHZ DIGITAL
RADIO SYSTEM
1
2
11
3
4
8
7
9
6
10
5
12
1. Steering Wheel
Controls direction (left/right) of the model
2. Throttle Trigger
Controls speed and direction (forward/brake/
reverse) of the model
3. ON/OFF Switch
Turns the power ON/OFF
4. Throttle Limiting Switch
Adjusts the throttle limit from
50%, 75%, and 100%
5. TH Rate
Adjusts the end point of the throttle
6. TH Trim
Adjusts the throttle neutral point
7. TH REV
Reverses the function of the speed control when
pulled back or pushed forward
8. ST REV
Reverses the function of the steering when the
wheel is turned left or right
9. ST Trim
Adjusts the steering center point
10. ST Rate
Adjusts the end point of the steering
11. Antenna
Transmits the signal to the model
12. Indicator Lights
• Solid red lights—
Indicates radio connectivity and
adequate battery power
• Flashing red lights—
Indicates the battery voltage is
critically low. Replace batteries
Содержание Shockwave 26
Страница 17: ...ShockWave 26 59 IT Notes...