ProBoat Shockwave 26, Руководство пользователя

Страница: 10 / 18

ShockWave
®
26
10
EN
• Drain water from inside the hull using the drain plug
• Fully dry the inside and outside of the boat, including
the water cooling lines and jacket around the motor
• Remove the hatch before storing your boat
• Repair any damage or wear to the boat
• Lubricate the flex shaft using Dynamite Marine
Grease (DYNE4200)
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions
Tip: The hook and loop strips in the boat retain water. To
dry them, press on them with a dry cloth.
NOTICE:
When you are finished boating, never leave the
boat in direct sunlight or in a hot, enclosed area such as
a car. Doing so can damage the boat.
After Boating and Maintenance
Rudder Service
1. Disconnect the water tube from the rudder.
2. Remove the linkage from the rudder arm with Ball
Link Pliers.
3. Turn the rudder and loosen the set screw from
the rudder pin.
4. Turn over the boat and lightly tap the rudder to
remove the pin.
5. Assemble in reverse order.
Propeller Service
1. Use an 7mm nut driver (DYN2804) to loosen
the nut from the driveshaft.
2. Remove the nut and propeller from the
driveshaft.
3. Assemble in reverse order. Correctly align the
propeller with the drive dog on the driveshaft.
Water Cooling System
If water does not stream out of the water outlets while
the boat is moving forward, immediately stop the boat
and clean the obstruction from the water cooling system.
1. Disassemble and clean the water cooling system to
remove blockage and prevent overheating.
2. Replace damaged parts.