Recoil® 26
1.
Install 4 AA batteries into the transmitter.
2.
Remove the canopy from the hull.
3.
Install the receiver antenna in the antenna tube.
4.
Install the fully charged battery in the compartment and
secure it with the hook and loop strap.
5.
Power on the transmitter. Ensure the throttle is not
reversed and the throttle trim is neutral.
6.
Connect the battery to the ESC.
7.
Keep the throttle at neutral and power on the ESC by
pushing and holding the power switch for 2 seconds until
the LED blinks.
• 3 beeps will sound, indicating the 3-cell Li-Po battery
is connected.
• 1 short beep will sound when the ESC is ready to
run.
8.
Install the canopy on the hull.
Range Check
IMPORTANT:
Perform a range check at the beginning of
each boating session, after repair or after installation of new
batteries.
Ensure the end of the receiver antenna is above the boat's
water line and all batteries are fully charged.
1.
With the radio system powered on and connected, walk
away from your boat 90 feet (32 m).
2.
Have an assistant remain with the boat to check for
proper control movement of the rudder in response to
your transmitter input.
3.
If everything appears to be operating correctly, prepare to
operate the boat in the water.
NOTICE:
Do not operate the motor without water cooling
circulation or damage may result.
Getting Started
NOTICE:
Do not cut or kink the receiver antenna or
damage may result.
2
2
1
2
3
2
5
2
6
7
4
5
EN
