Recoil® 26
Transmitter Controls
Battery Level Indicator
Solid Red and Green:
Battery voltage is
good (above 4V).
Solid Red: Battery
voltage is critically low
(below 4V). Replace
transmitter batteries.
Power Switch
Power on or off the transmitter
Steering Wheel
Control steering.
Right and Left
steering
Throttle Trigger
Controls power
to the motor
for forward
or reverse
Stop
Adjusts the neutral
point of the electronic
speed control
Throttle Trim
Steering Dual Rate
Adjusts the amount
the rudder moves
when the steering
wheel is turned
left or right
Adjust to make
the vehicle drive
straight with
no input at the
steering wheel
Steering Trim
Reverse Switch
Allows you to change the direction of
steering (ST. REV) and throttle (TH. REV)
controls (Ensure proper function with a
radio system test).
Throttle Dual Rate
Adjusts the maximum
amount of throttle the
vehicle can be given
Transmitter Battery Installation
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from
the transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
Reverse
Forward
Battery Charger
(A charger is not included with boats sold in Canada.)
NOTICE:
Never charge a battery in the boat or damage
may result.
1.
Connect the AC power cord to the power slot on the
charger, then connect the other end of the power cord to
an AC power source.
2.
The three LEDs will turn GREEN when the charger is
connected to the AC power source.
3.
Connect the balance connector of the battery pack to the
proper connector on the charger (the 3S connector has 4
pins and the 2S connector has 3 pins).
4.
The three LEDs will turn RED, indicating the battery is
charging.
5.
When the charging of one cell is complete, the
corresponding LED turns GREEN.
6.
Once the battery pack is fully charged, all three LEDs will
turn GREEN.
7.
Disconnect the balance connector
and battery from the charger.
4
EN
