Recoil® 26
Rudder Trim
If the boat does not go straight, adjust the steering trim dial
on the transmitter.
If you are using all the steering trim on your transmitter to
make the boat drive straight, return the trim to neutral and
mechanically center the rudder. To do this, loosen the hex
nut (
A
) from the rudder horn (
B
), then adjust the linkage (
C
)
until the rudder is properly centered.
Water Cooling System
If water does not stream out of the water outlets while the
boat is moving forward, immediately stop the boat and clean
the obstruction from the water cooling system.
1.
Disassemble and clean the water cooling system to
remove blockage and prevent overheating.
2.
Replace any damaged parts.
Binding
The included transmitter and receiver are bound at the
factory. To rebind:
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code of a
single specific transmitter.
1.
Power off the transmitter and ESC.
2.
Connect a fully charged battery pack to the ESC.
3.
Power on the ESC. The RED LED on the ESC flashes.
4.
Press the bind button (
A
) on the receiver.
The RED LED on the ESC flashes rapidly.
5.
Power on the transmitter.
6.
The RED LED on the ESC turns solid when
the radio system is bound.
You must rebind when binding the receiver to a different
transmitter. You must also recalibrate the ESC after
rebinding.
NOTICE:
Do not attempt to bind the transmitter and
receiver if there are other compatible transmitters in
bind mode within 400 feet. Doing so may result in
unexpected binding.
CH4
CH3
CH2
CH1
SW
B/C
4
CH
2.4GH
Z
A
A
C
B
8
EN
