Miss Geico 24
Installing the Battery Pack
1. Turn the latch so the tab is parallel with the back of
the hull, then lift the hatch up and back from the hull.
2. Remove the radio box cover.
3. Install the included hook and loop tape on the battery
pack. Install the battery on the hook and loop strips in
the compartment.
Tip: Move the pack forward or back to adjust the center
of gravity for your boat. Move the pack toward the bow
so the bow rides lower in the water. Move the pack away
from the bow so that the bow rides higher in the water.
4. Connect the battery pack to the ESC power
connectors.
5. Disassemble in reverse order.
3
4
1
2
5
EN
Antenna Tube Installation
1. Carefully feed the end of the receiver antenna
through the grommet inside the hull.
2. Pull the antenna wire out of the grommet
towards the outside of the boat, then slide
the antenna through the antenna tube.
3. Insert the tube into the grommet, then
fit the cap onto the tube.
4. Apply clear tape to the antenna, grommet
and hull in the boat to keep the antenna
from moving.
The antenna must be installed above the boat's waterline
to get the best reception of your transmitter's signal.
NOTICE:
Do not cut or kink the receiver antenna
or damage may result.
