PROAIM Kite-33 Starter, Руководство по установке и эксплуатации

Страница: 6 / 14

PROAIM KITE-33 STARTER PACKAGE 6

Slide Section 8 into Section 9 and join with ring pin (163mm).

Install the pin at the first join holes of the
sections and bolt, washers and nut from
side at the second holes of section.
First hole
Second Hole

Similarly insert all the sections one by one (small to the big) and install the pin and bolt , washers
and nut to secure each section.

Take out the middle clamp and open it by unscrewing the bolt. Then install the Clamp on Section 7
and tighten the clamp’s allen bolt with allen key to secure properly. After that, attach the rods to
the clamp’s pillars (two at sides and one on top of the clamp).
This Ring Pin is to avoid the play in Jib.
This knob is for tightening the Jib sections.
IMPORTANT

Take out the smallest clamp and open it by unscrewing the bolt. Then install the Clamp on Section 1,
attach it with pin and tighten the clamp’s allen bolt with allen key to secure properly.