Usage instructions for NJ1 adaptive bike
6
Figure 2: Anti-roll back device
Proper use of the product is a basic require-
ment of safe operation. The product may gen-
erally be used only for applications that are
listed and described in these usage instruc-
tions. This includes storage, transport, mainte-
nance/inspection, and repair, as well as the
safety information in each chapter of these
usage instructions.
8 Technical specifications
8.1 Product weight
The total weight starts from 8.3 kg with the
basic equipment.
8.2 Load weight
Maximum load weight:
120 kg towing capacity and 10 kg payload
The heavy-duty version and individual custom-
isations can be designed for a higher load; this
is then indicated on the rating plate. In this
case, an adapter is required for heavier loads.
The Heavy Duty version of the adapter is ap-
proved for 120 kg - 200 kg.
When operating the product, the wheelchair
usage instructions must also be observed.
Information on limit values must not be ex-
ceeded. If the values in the two sets of usage
instructions differ, the lower limit is the one
which applies.
8.3 Obstacle height and turning circle
Maximum drive-over/negotiable obstacle
height:
10 cm (must be ensured through an
appropriate adapter assembly/setting, caster
wheels must be removed (
recommended
equipment of the wheelchair: caster forks with
quick-release axle))
This value can, however, be reduced due to
the specifications of the type of wheelchair or
its settings. Therefore, you should observe the
values given in the wheelchair's usage instruc-
tions or the restrictions dependent on the set-
tings.
Turning circle:
approx. 4 m without manoeuvring back and
forth
approx. 2.6 m with manoeuvring back and
forth (strongly dependent on the number of
manoeuvres)
8.4 Basic equipment and dimensions
In the basic equipment, the product comprises
a drive unit with docking plate, handles with
switching brake fittings, chain shift or hub
gears shift, rim brake including handbrake
locking mechanism and hydraulic disk brakes
or back-pedal brake. Furthermore, there is a
light set and a mudguard on the product.
Dimensions, NJ1 adaptive bike:
Product height: approx. 75 - 110 cm (depend-
ing on the wheel size and length of the bottom
bracket support)
Product width: approx. 45 - 63 cm (depending
on the grip width, parking stand in passive
position)
Grip width: 40 - 58 cm
Crank length: 155 - 195 cm
8.5 Service life
The service life of the product is 6 years.
