Usage instructions for NJ1 adaptive bike
11
16 Ending the driving operation
To make getting out of the wheelchair more
simple, the product can be disconnected from
the wheelchair (see usage instructions "Adapt-
er and adaptation").
17 Adapter and adaptation
Where necessary and ordered, a suitable
adapter for your wheelchair is included with the
delivery.
Please read the usage instructions and as-
sembly usage instructions "Adapter and adap-
tation" before using the product.
The product may only be adapted and
detached on dry, stable and flat surfaces.
The adapter must at least have the same
user weight approval as the product.
18 Drive wheel and tyre pressure
Check the tyre inflation pressure at regular
intervals as well as after extreme temperature
effects. The
recommended tyre pressure is
printed on the side of the tyre
. This should
be observed.
Insufficient tyre pressure has a negative
effect on the handling. Apart from that, there is
an increased risk of a flat tyre.
If the pressure is too high, the tyre may
burst. For this reason, product tyres may not
be exposed to unusually high temperatures
such as under glass in the summer.
When inflating the tyres, make sure that
the prescribed air pressure is not exceeded.
To check or correct the tyre pressure
, pro-
ceed as follows:
1. Secure the product to prevent it rolling
away.
2. The drive wheel is normally fitted with a car
tyre valve. Unscrew the valve cap.
Figure 3: Valve with cap
3. Place the valve attachment of the com-
pressed air device or the compressor onto
the valve and, if a clamp lever is available,
secure the connection by applying the
clamp lever.
4. Now check the tyre pressure. If the tyre
pressure does not match the specifica-
tions, correct it.
5. Finally release the clamp lever (if present),
pull the valve attachment off the valve and
replace the valve cap.
Figure 4: Compressor
Valve with cap
