Operating instructions LITTY 4you
10
Once the position of the back shell has been
set, tighten the M5 fixing screws (AF 3 mm)
using 4 Nm torque again. The associated nuts
(AF 5mm) must be tightened for this.
Please note that if you move the back shell
further back, this will move the centre of gravity
further back which makes it easier to tip the
product up (Chapter 16.6).
16.3 Adjusting seat width
To widen the product, widening sets can be
ordered which are may up of an axle tube, seat
plate, back shell and back cross bar as well as
footrest support tubes or foot plate in a corre-
sponding size.
Figure 6: Back cross bar and axle bar, view of prod-
uct from rear
Contact your specialist retailer if you want to
change the width of the seat.
16.4 Adjusting the seat depth
To adjust the seat depth to suit body dimen-
sions, the distance between the seat plate and
back shell can be infinitely adjusted. The ad-
justment is made by undoing the two M6 fixing
screws (AF 4 mm) on each side in the rotation
points.
Figure 7: Fixing screws on the seat plate in the
rotation points
Afterwards, the seat plate is shifted along the
slots on the fixing screws.
Figure 8: Possible directions of movement of the
seat plate with slots
Afterwards, tighten the M6 fixing screws (AF 4
mm) on the rotation points again using 7 Nm
torque.
After adjusting the seat plate, it may be neces-
sary to adjust the position of the back shell.
Please pay attention to the advice in Chapter
16.2.
16.5 Adjusting the lower leg length
adjusting the footrest
The footrest support tubes are clamped on the
left and right onto the lower frame tubes into
the foot bracket clamps. The foot bracket
clamps are secured against twisting through
interlocking serration.
Axle tube
Back cross bar
M6 fixing screws
