Proaction A105QS, Инструкция по установке и эксплуатации

Страница: 14 / 19

Before cleaning your washing
machine.
a: Unplug your machine from the mains power
supply.
b:
Close the water tap.
Water inlet filters
On the tap part of your machine’s water inlet
hose and at the ends of water inlet valves, there
are filters to prevent entrance of the dirt and
foreign materials in the water to the machine. If
the machine is unable to receive sufficient water
although your water tap is fully opened, these
filters should be cleaned.
• Remove the water inlet hose.
•
Remove the filters found on the water inlet
valves by using a pincer and wash thoroughly
with a brush.
(1)
•
Clean the filters of the water inlet hoses
located on the tap side by removing manually
together with the seal.
(2)
•
After you clean the filters, you can fit them
the same way as you have removed them.
Pump filter
The pump filter system elongates the life of your
pump, which is used to drain the dirty water. It
prevents lint enter the pump. Cleaning of your
pump filter every 2-3 months is recommended.
To clean your pump filter:
•
Open the kickplate’s cover, by pulling the
handle.
(2-A & 3-A)
• Before opening the filter cover,place a cup in
front of the filter cover to prevent flow of the
remaining water in the machine.
•
Loosen the filter cover by rotating it counter
clockwise and drain the water.
(4-A)
•
Remove the foreign materials from the filter.
•
Check for the rotation of the pump manually.
•
After you have cleaned the pump, fit the filter
cover by rotating clockwise.
•
Put the kickplate cover into place.
•
Do not forget that if you do not fit the filter
cover properly, it will leak water.
Danger of being scalded!
The water inside the pump
maybe hot- wait for it to cool.
1
2
Care and Maintenance
Customer Helpline: 0845 600 4632
13