Pro PRO-790, Руководство по эксплуатации

Страница: 6 / 46

6 888-545-1254 | www.PrecisionRatedOptics.com
PRO-790
15) Use the supplied AC power cord. Do not place heavy objects on the AC power cord. Do not pull heat up
or modify the AC power cord. Use of an improper cord or a damaged cord may cause fuming, electric
shock or equipment damage and may result in personal injury, death or fire.
16) Connect the AC power cord properly to the splicer and wall socket. When inserting the AC plug, make
sure there is no dust or dirt on the terminals. Incomplete engagement may cause fuming, electric shock or
equipment damage and may result in personal I jury, death or fire.
17) It uses a three-prong (core) AC cord that contains an earthed ground safety mechanism. The splicer
MUST be Grounded/Earthed. Use only the supplied three-prong (core) AC power cord. NEVER use a
two-prong (core) power cord, extension cable or plug.
18) Use only the approved battery pack with the machine. Only the battery pack can be used as the approved
battery pack.
19) Use the specified charger cord to recharge the battery pack. Using other battery chargers and charger
cords may cause fuming or equipment damage and result in personal injury, or death and it could cause a
fire.
20) The splicer inlet is used to disconnect the power cord in the event of a fault. Be sure to position the splicer
so that the power cord can be disconnected easily and quickly.
21) Disconnect the AC or DC power cord from the splicer inlet or the wall socket (outlet) immediately if the
splicer or the external battery emits fumes, a bad smell, or becomes noisy or hot. Leaving the abnormal
condition unattended will cause equipment failure, electric shock or fire and may result in personal injury,
death or fire.
22) Disconnect the AC or DC power cord from the splicer inlet or the wall socket (outlet) immediately if
liquid (e.g., water) or foreign matter (e.g., screw) enters the splicer. Leaving the splicer in a damaged state
may cause equipment failure, electric shock or fire and may result in personal injury, death or fire.
23) Caution should be taken when removing the fiber protection sleeve from the tube heater after the heat
shrink cycle is completed. The tube heater and fiber protection sleeve are hot and should not be touched.
Possible burn may result
24) Replace the electrodes properly.
o
Use only specified electrodes.
o
Set the new electrodes in the correct position.
o
Replace the electrodes as a pair.
Disregard of the above instructions may cause abnormal arc discharge and result in equipment damage or
degradation in splicing performance.
25) The equipment must be repaired or adjusted by a qualified technician or engineer. Incorrect repairs may
cause fire or electric shock. Should any problem arise, please contact your nearest sales agency.