V1.0
8355331
Please read and understand all instructions before use. Retain this
manual for future reference.
ASSEMBLY & INSTALLATION
WARNING! Do not hold or press the lower handle against
yourself or an object while removing a set of jaws. This can close
the jaws and cause a crushing injury to your fingers or hand.
Letter references in parenthesis (A) refer to the included
Identification Key.
1. Push the release lever (I) towards the jaws to release the
ratchet mechanism.
2. Spread the handles (G) apart to open the jaws. Push the
release mechanism forward to avoid catching the ratchet
mechanism.
3. Hold the upper handle only and press your thumb against
the inside of the lower handle to prevent it from closing.
4. Grip the upper jaw (A) on the top and bottom. Pull straight
out to remove the jaw. Repeat with the lower jaw.
5. Replace the jaw set with the appropriate set for crimping
(see Table 1).
6. Close the jaws when not in use to prevent accidentally
closing it on a body part.
OPERATION
1. Prepare the wire by removing enough insulation from the
end to insert into the terminal.
2. Select the jaws appropriate for the terminal type that
requires crimping and install in the crimper.
2.1 Each set of jaws has a stamped letter for identification
(see Table 1).
3. Place the terminal in the lower jaw that corresponds to the
wire size (gauge or mm) and slowly squeeze the handles until