Pro Lite E32-A, Руководство пользователя

Страница: 13 / 21

Pro-Lite, Inc.
E32-A user manual
12
Receiving
In mode 2, it is required the data transmitter works in mode 1.
The wireless module monitors the preamble code at regular time.
Once it gets the preamble code, it will remain as receiving status and waiting for the completion of receiving the
entire valid data package.
Then the AUX outputs low level, 5ms later the serial port is open to transmit received wireless data through
TXD. Finally, AUX outputs high level after process completed.
The wireless module stays in “power-saving – monitoring” working status (polling).
By setting different wake-up time, the module will have different receiving response delay (2s in maximum) and
average power consumption (30uA in minimum).
The user needs to achieve a balance between communication delay time & average power consumption.
6.5 Sleep mode (mode 3)
When M1=1, M0=1, module works in mode 3
Transmitting N/A
Receiving N/A
Parameter
setting
This mode can be used for parameter setting. It uses serial port 9600 & 8N1 to set module working parameters
through specific instruction format. (pls refer to parameters setting for details)
Notes
When the mode changes from stand-by mode to others, the module will reset its parameters, during which the
AUX keeps low level and then outputs high level after reset completed. It is recommended to check the AUX
rising edge for user.
7 Command format
In sleep mode （ Mode 3 ： M1=1, M0=1 ） , it supports below instructions on list.
(Only support 9600 and 8N1 format when setting)
No.
Instruction
format
Illustration
1
C0+working
parameters
C0 + 5 bytes working parameters are sent in hexadecimal format. 6 bytes in total and must
be sent in succession, ( Save the parameters when power-down ).
2 C1+C1+C1
( Save the parameters when power-down )
3
C2+working
parameters
Three C1 are sent in hexadecimal format. The module returns the saved parameters and
must be sent in succession.
4 C3+C3+C3
C2 + 5 bytes working parameters are sent in hexadecimal format. 6 bytes in total and must
be sent in succession. ( Do not save the parameters when power-down )
5 C4+C4+C4
Three C3 are sent in hexadecimal format. The module returns the version information and
they must be sent in succession.
7.1 Default parameters
type Default parameter values
：：
C0 00 00 1A 17 44
Model Frequency Address Channel Air data rate Baud rate Parity
Transmitting
power
E32-A 433MHz 0x0000 0x17 2.4kbps 9600 8N1 100mW