Pro Lite E32-A, Руководство пользователя

Страница: 18 / 21

Pro-Lite, Inc.
E32-A user manual
17
9.2 Module is easy to damage

Please check the power supply source, ensure it is 2.0V~3.6V, voltage higher than 3.6V will damage the module.

Please check the stability of power source, the voltage cannot fluctuate too much.

Please make sure antistatic measure are taken when installing and using, high frequency devices have electrostatic
susceptibility.

Please ensure the humidity is within limited range, some parts are sensitive to humidity.

Please avoid using modules under too high or too low temperature.
9.3 BER(Bit Error Rate) is high

There are co-channel signal interference nearby, please be away from interference sources or modify frequency and
channel to avoid interference;

Poor power supply may cause messy code. Make sure that the power supply is reliable.

The extension line and feeder quality are poor or too long, so the bit error rate is high;
10 Production guidance
10.1 Reflow soldering temperature
Profile Feature Curve characteristics Sn-Pb Assembly Pb-Free Assembly
Solder Paste Solder paste Sn63/Pb37 Sn96.5/Ag3/Cu0.5
Preheat Temperature min
（
Tsmin
） Min preheating temp. 100℃ 150℃
Preheat temperature max (Tsmax) Mx preheating temp. 150℃ 200℃
Preheat Time (Tsmin to Tsmax)(ts) Preheating time 60-120 sec 60-120 sec
Average ramp-up rate(Tsmax to Tp) Average ramp-up rate 3℃/second max 3℃/second max
Liquidous Temperature (TL) Liquid phase temp. 183℃ 217℃
Time
（
tL
）
Maintained Above
（
TL
）
Time below liquid phase line 60-90 sec 30-90 sec
Peak temperature
（
Tp
） Peak temp. 220-235℃ 230-250℃
Average ramp-down rate
（
Tp to Tsmax
） Average ramp-down rate 6℃/second max 6℃/second max
Time 25℃ to peak temperature
Time to peak temperature for
25℃
max 6 minutes max 8 minutes