9
5. Set the Console (103) on the handrail assembly.
Be careful not to pinch the wires.
Attach the Console (103) on the handrail assem-
bly with two 3/8" x 1 3/4" Patch Bolts (3) and two
3/8" Star Washers (4).
Start both Patch Bolts
before tightening either of them.
5
6.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see pages 19 and 20).
103
3
Handrail
Assembly
4
3
4
If you purchase the optional chest pulse sensor (see page 16), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1.
Make sure that the power cord is unplugged.
Remove the indicated M4.2 x 13mm Screw (7)
and the Access Door (107) from the Console
Base (106).
2. Connect the wire on the receiver to the indi-
cated wire extending from the Bottom of the
Console Base (106).
Hold the receiver so the
antenna is oriented as shown and is facing
the treadmill user.
Attach the receiver to the
plastic posts on the Access Door (107) with the
two included small screws.
3.
Make sure that no wires are pinched.
Reattach the Access Door (107) with the M4.2 x
13mm Screw (7). Discard the other wires in-
cluded with the receiver.
Receiver
107
Antenna
7
106
Wires
