13
5. Follow your progress with the displays.
The matrix
—When you
select the manual mode,
the matrix will display a
track that represents 1/4
mile (400 meters). As
you exercise, the indica-
tors around the track will appear in succession until
the entire track appears. The track will then disap-
pear and the indicators will again begin to appear
in succession.
The Time/Incline dis-
play
—The Time/Incline
display can show the
elapsed time. The dis-
play will also show the
incline of the treadmill
for several seconds each time the incline changes.
Note: When a workout is selected, the display will
show the time remaining in the workout instead of
the elapsed time.
The Calorie/Pulse dis-
play
—The Calorie/Pulse
display can show the ap-
proximate number of
calories you have
burned. The display will
also show your heart rate when you use the hand-
grip pulse sensor or the optional chest pulse sen-
sor.
The Distance/Speed
display
—The
Distance/Speed display
can show the distance
that you have walked or
run and the speed of the
walking belt.
To reset the console, press the Stop button, re-
move the key, and then reinsert the key.
6. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same
time, the console will not display your heart
rate accurately.
See page 16 for information
about the optional chest pulse sensor.
Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from the
metal contacts.
In addition,
make sure that
your hands are
clean.
To measure your heart rate,
stand on the foot
rails
and hold the metal contacts on the handrail—
avoid moving your hands. Hold the contacts for
approximately ten seconds.
When your pulse is
detected, your heart rate will be shown.
For the
most accurate heart rate reading, continue to
hold the contacts for about 15 seconds.
7. Turn on the fan if desired.
The fan features high and low speed settings.
Press the Fan button repeatedly to select a fan
speed or to turn off the fan. Note: If the fan is on
when the walking belt is stopped, the fan will turn
off automatically after a few minutes.
8. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when you fold the treadmill to the storage posi-
tion, or you may damage the treadmill.
Next, re-
move the key from the console and put it in a secure
place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts