6
7. Attach the Seat (12) to the Seat Post (5) with four M8
Nylon Locknuts (37) and four M8 Split Washers (36).
Note: The Nylon Locknuts and Split Washers may
be preattached to the Seat.
6. While another person holds the Console (6) near the
Upright (3), connect the console wire harness to the
Upper Wire Harness (32).
Insert the excess Wire Harness (32) downward into the
Upright (3). Attach the Console (6) to the Upright with
four M4 x 16mm Screws (25).
Make sure that the
Wire Harness is not pinched.
3
25
32
6
Console Wire
Harness
25
6
12
5
36
37
7
8. Remove the packing tube from the Frame (1), and dis-
card the packing tube.
Turn the Seat Knob (11) counterclockwise two or three
turns to loosen it (if the Seat Knob is not loosened
enough, it may scratch the Seat Post [5]). Next, pull the
Seat Knob, insert the Seat Post into the Frame (1), and
then release the Seat Knob.
Move the Seat Post up
and down slightly until the pin on the Seat Knob
snaps into one of the holes in the Seat Post.
Then,
turn the Seat Knob clockwise until it is tight.
5
11
Packing
Tube
8
1
