8
7. The Console (5) can use four 1.5V “D” batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been exposed
to cold temperatures, allow it to warm to room
temperature before inserting batteries.
Otherwise, you may damage the console dis-
plays or other electronic components.
Remove
the battery cover, insert the batteries into the battery
compartment, and reattach the battery cover.
Make
sure to orient the batteries as shown by the dia-
gram inside the battery compartment.
To purchase an optional AC adapter, contact the
store where you purchased this product or call
the telephone number on the cover of this man-
ual. To avoid damaging the console, use only a
manufacturer-supplied AC adapter.
Plug one end
of the AC adapter into the jack on the console; plug
the other end into an outlet installed in accordance
with all local codes and ordinances.
Battery
Cover
Batteries
Batteries
Tab
7
5
8. While another person holds the Console (5) near
the Upright (3), connect the wire harness on the
Console to the Upper Wire Harness (48). Insert the
excess wire harness into the Upright. Next, attach
the Console to the Upright with four M4 x 16mm
Round Head Screws (101).
Be careful to avoid
pinching the wire harness.
48
5
3
101
Wire
Harness
8
6. While another person holds the Upright (3), connect
the Upper Wire Harness (48) to the Lower Wire
Harness (49).
Gently pull the upper end of the
Upper Wire Harness to remove any slack,
and
insert the Upright into the Base (1).
Attach the Upright (3) to the Frame (1) with an M8 x
70mm Button Bolt (80), an M8 Split Washer (90),
and an M8 Jamnut (79).
Do not tighten the Button
Bolt yet; make sure that the Jamnut is in the
hexagonal hole in the Base.
Next, finger tighten two M8 x 23mm Patch Screws
(84) with two M8 Split Washers (90) into the Base
(1).
Do not tighten the Button Screws yet.
Attach the Water Bottle Holder (22) to the Base (1)
with two M4 x 16mm Blunt Screws (104).
3
80
48
49
22
84
84
90
90
90
104
79
1
6
