Pro-face PS-3000B Series, Руководство по оборудованию

Страница: 70 / 83

Chapter 3 Installation and Wiring
3-15
(3) Fix the USB holder with a screw. The torque required for this screw is 0.5 to 0.6N
•
m. Next, as shown,
insert the USB Cable Clamp’s band through the bridge. Pass the USB cables through the Cable Clamp’s
band and securely tighten the clamp band around the cables.
(4) For PS3000-BA, replace the Expansion Board Cover and reattach two (2) attachment screws.
The torque required for these screws is 0.5 to 0.6N
•
m.
„
Removing the USB Cable Clamp
(1) To remove the clamp from the USB cables, push down on the clamp strap’s clip to release it while
pulling up on the clamp.
• Be sure the clamp is securely holding the USB cable’s plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing upwards - not to
the side. This is to keep the clamp from interfering with nearby connectors and their
cables.
Band
Clamp
USB Cable
Cable collar
Clip
Clamp