Pro-face GP-4114T, Руководство по установке

Страница: 19 / 39

20
E
ngl
is
h
Installation
Installing to panel cutout for Color Model
Step Action
1 Place this product on a clean and level surface with the screen
facing down.
2 Check that this product’s gasket is seated securely into the
bezel’s groove, which runs around the perimeter of the display
panel frame.
NOTE : Always use the installation gasket, since it absorbs vibration in
addition to repelling water. For the procedure on replacing the installation
gasket, refer to the GP-4100 Series Color Model Hardware Manual.
3 Based on this product’s panel cutout dimensions (see page 15),
open a mount hole on the panel and attach this product to the
panel from the front side.
4 Insert the installation fastener hooks into the insertion slots on
this product.
In a clockwise direction, tighten the installation fastener's screws
with a screwdriver.
There are two insertion slots on both the top and bottom of this
product.
The necessary torque is 0.35 N•m (3.1 lb-in)
NOTE : If you exceed the recommended torque when tightening the
installation fastener’s screws, the front of this product may become distorted.