4
Required Equipment and Accessories
Transmitter
AA battery (4)
Motor battery (2) (charged)
Hook and loop tape
1. Locate the pieces for the boat stand.
The longer side pieces will key to the
shorter end pieces. Use a small amount of
Medium CA to glue the pieces together.
2. Slide the cover from the bottom of the
transmitter to access the battery holder.
3. Install the four AA batteries in the
battery holder. Match the polarity of the
batteries to the molded markings in the
battery holder.
4. Slide the battery cover back on the
bottom of the transmitter.
5. Lift the hatch cover from the hull at
the rear and slide it back to remove.
The cover is held at the rear using two
magnets, and at the front with a small pin.
Basic Assembly
