Instruction manual
16
How to prepare therapy
6. Plugging the nebulizer into the electrical power
Device can operate connected directly to mains electrical outlet (220V AC) or to a car
cigarette lighter adapter (12V DC).
Plugging into mains electrical outlet (220V AC)
Make sure that the power button
⓮
is in the OFF/0
position. If the power cord
⓲
is not attached, insert it
fully in the socket of the nebulizer
⓰
and plug it into an
electrical outlet.
Note: Mains socket outlet used for connection of the
control unit to the mains shall be easily reachable to the
operator.
Plugging into car cigarette lighter adapter (12V DC)
Connect DC power cable
⓳
running from car cigarette
lighter adapter to socket on the rear side of unit
⓱
.
Observe the keyhole at the top of the connector on DC
power cable
⓳
. Keyhole prevents wrong assembly of the
plug.
7. Turning the nebulizer on, pausing
Turn on power button
⓮
, on a back side of device.
Press Start/Stop button
❿
to start therapy.
It will start if the water tank is filled with cooling water.
If the water level in the water tank is too low, device will
signalise error trough blinking of Start/Stop button
❿
.
Fill water tank as described in section 2. Then press
Start/Stop button
❿
again to start inhalation.
You may temporarily pause the inhalation session by
pressing the Start/Stop button. The inhalation session may
be continued by pressing the same button again.
