Prism Medical A205, Руководство пользователя

Страница: 29 / 44

A205 Mobile Hoist User Manual Page 29 of 44 Part No. 999003 / Rev.2 / Nov 2017
17. Do’s and Don’ts
DO
•
Do charge the battery whenever possible. This will extend the battery
life. A large number of cycles can be obtained from operating on the
batteries, but battery lifetime is reduced with frequent discharging.
•
Do inspect all cables particularly the mains power cable on the charger
for any damage; replace where necessary.
•
Do stow the handset and if fitted with charger, the mains power cable
when transporting the hoist.
•
Do clean the actuators, control box, charger, battery and handset at
regular intervals to remove dust and dirt.
Take great care to ensure that no liquids get inside the hoist. This hoist is
not drip proof or water tight. Failure to protect the hoist from liquids
may result in damage to the hoist and/or may cause personal injury.
DON'T
•
Don't allow the batteries to fully discharge before connecting to the
charger. The batteries are a lead-acid gel cell type that can be trickled
charged continuously (batteries used for standby) and have a high
current discharge capacity. Life is greatly reduced by deep or complete
discharging of the batteries. Longer lifetime is obtained by maintaining
fully charged batteries.
•
Don't continue to operate the handset by repeatedly pressing the
buttons if the hoist function will not move or the actuator will not
function. If this occurs, then the actuator has either reached its end
position, the load is too great or there is a malfunction.
•
Don't exert excessive force on the handset cable as this may break off
the wires inside the cable and prevent some or all of the operations.
•
Don't continually operate the hoist functions. The system is not designed
for continuous operation. Continuous operation will cause batteries to
be deeply discharged or to damage the actuator or control box by
overheating.
The exterior of the hoist should only be cleaned, disinfected or sterilized (if
required) using isopropyl alcohol.
Damp a cloth with isopropyl alcohol and wipe down entire exterior of hoist.
No other chemicals and/or liquids should be used to clean, disinfect and
sterilize this hoist.