Prinzen PSPC5, Руководство по обслуживанию

Страница: 46 / 73

PACKER
Page 46 of 73 SERVICE MANUAL PSPC5 SM-PSPC5-01-E/12-2007
EGG LIFTER POSITION
When the machine is stopped, the distance
between the star shaped cam and the next
roller must be approximately 10 mm (50).
To check and to adjust this, measure it or use
a block with a 10 mm thickness (51).
When adjustment is needed follow below
steps:
52. Remove 2 shafts with rollers from the
transport chains. Do this from the bottom
side of the roller track.
53. Push the chain towards the side of the
system.
54. Push the shaft with rollers towards the
other side of the system.
55. Bring the gap in the roller track towards
the star shaped cam by pushing the start
button on the operating panel while the
clear button is set to position 1.
56. Stop the roller track when the last shaft
with rollers before the gap is at the cam
position.
57. Loosen up 1 set screw of the cam. Place
the 10 mm block in between the roller and
the cam. Press the cam towards the block
and tighten op the setscrew.
58. After all cams are adjusted, bring the gap
in the roller track back to the bottom side
of the system and place back the 2
removed shafts with rollers.
53
54
52 50 51
55
56
55
56 57