Printronix L7032, Быстрая настройка

Страница: 7 / 50

7
Basic Setup
This Quick Setup Guide shows you how to set up and test your
L7032 printer. For information on configuring the printer for use with
a computer or network, attaching the data cable, ordering spare
consumables, etc., refer to the User’s Manual, which is on the CD-
ROM attached to the back cover of this guide.
The fact that you are reading this means you have unpacked your
printer from the shipping carton and removed the plastic bag and
accessories. You will now select a printer site, prepare the printer
for operation, and print a test page.
Choose a Space for the Printer
Figure 1 shows the minimum clearances you need to install,
operate, and maintain the printer. You need a space at least 80
inches (2032 mm) wide—more if you have the optional power
paper stacker—and 55 inches (1397 mm) deep:
1. You need at least 28 inches (711.2 mm) at the front of the
printer to open the front access door and replace consumables.
2. You need at least 28 inches (711.2 mm) on the paper-input
side of the printer to load paper.
3. You need at least 28 inches (711.2 mm) on the paper-exit side
of the printer to stack and remove the printed media.
If you are using the optional power paper stacker, leave
sufficient room for it.
4. Leave at least six inches (152.4 mm) between the back of the
printer and the wall to allow air circulation. The printer's fans
vent air out the back of the printer.