Printek FP5000 series, Руководство пользователя

Страница: 48 / 201

User guide The control panel
35
Messages in the LC
display
If the printer detects an internal fault or user error or if it expects you
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g.
Initializing ). Below you
will find a list of messages with brief descriptions of each message.
The messages are described in greater detail in the chapter
Error
messages via the display (page 122) .
Message Meaning
Eject error
The printer cannot eject the paper/
advance it to park position.
Hardware Alarm
Internal hardware error. Try power
cycling the printer. If the message
appears again, contact your dealer or
service technician.
Initializing
This message appears during the
printer’s initializing phase after switch-
ing on the printer.
Load error
The printer cannot draw in the loaded
paper.
Load paper from
The printer has detected paper end
during operation/printer was switched
on with no paper loaded.
Loading default
Factory defined parameters will be
reloaded in all available menus after
switching on the printer.
Out of paper
The printer has detected paper end
during operation / printer was switched
on with no paper loaded.
Paperwidth error
Print characters override the detected
right paper margin.
Parity error
A parity error during data transmission
is indicated.
Park position
Paper is not being fed into print posi-
tion.
Press any key
The user is requested to press any
key.
PW sensor defect
The automatic paper width detection
cannot detect the left paper margin.
Selftest
After power-on, the printer executes a
short hardware self-test.