Figure 2
2.
Attach Cross Tube (
#7
) to Caster Beam Assemblies using four Thumb Screws (
#28
) as shown
in
FIGURE 2.
Tighten bolts snug but
DO NOT
over tighten.
READ AND FOLLOW ALL ASSEMBLY, OPERATING,
AND SAFETY INSTRUCTIONS CAREFULLY . AT LEAST
TWO (2) ADULTS ARE NEEDED TO PUT THIS TABLE
TOGETHER!
Parts Needed:
1 pc -
#7
Cross Tube
Hardware Needed:
4 pcs -
#28
#10-24 Thumb Screw
1.
Slide a Caster Wheel
with
Lock (
#30
) into Caster Beam
as shown in
FIGURE 1
. On the other end of the Caster
Beam attach a Caster Wheel
without
Lock (
#9
).
Make sure you have one Caster Wheel with lock and a
Caster Wheel without lock for each Caster Beam.
Repeat this step to attach the Casters to the second
Caster Beam.
9
9
9
8
8
Parts Needed:
2 pcs -
#8
Caster Beam
2 pcs -
#9
Caster without lock
2 pcs -
#30
Caster with lock
Rubber Hammer
Figure 1
4
7
30
with lock
30
without lock
with lock
without
lock
8
30
NOTE:
Make sure the Caster
Stem is completely installed
into Caster Beam as shown.
28
