Prince Castle CTD, Оригинальное руководство пользователя

Страница: 12 / 23

CTD & CTDE
Vertical Contact Toasters
12 301-500rev
E
-EN
Troubleshooting
WARNING
To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be
performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are
required. Use extreme care during electrical circuit texts. Live circuits will be exposed.
WARNING
BURN/ELECTRICAL SHOCK HAZARD! Platen is HOT and can cause severe burns or severe shock.
Keep hands and objects out of the toaster unit! Failure to exercise caution may result in serious injury!
Turn the unit off, unplug it and let it cool down completely before touching or working on internal apparatus. The plug removed
from the outlet shall remain clearly visible to the operator during the maintenance procedure.
PROBLEM POSSIBLE CAUSE SOLUTION
Unit has no power
Unit unplugged Plug unit in.
Breaker tripped Reset breaker.
Loose connection on power switch
Call Tech Support 1-800-722-7853
Inoperable power switch
Unit will not heat up
Loose connection on platen
Call Tech Support 1-800-722-7853
Open platen
Loose connection to the main control board
Inoperable main control board
Inoperable TRIAC
Unit heats up, but the conveyors
do not run
The conveyor door is ajar Verify that the door is closed.
Inoperable motor
Call Tech Support 1-800-722-7853
Stripped drive gear
Stripped conveyor gear
Jammed conveyor assembly
Not toasting properly (under- or
over-done)
Inoperable RTD -probe Call Tech Support 1- 8 00-722-7853
Improper set point
Adjust set point in programming (see Setting
Adjustments section).
Improper compression
Adjust compression (see Setting Adjustments
section).
Torn or soiled release sheet Clean or replace release sheet.
Bad platen Call Tech Support 1-800-722-7853
Jumpy or blank display
Improper ground
Call Tech Support 1-800-722-7853
Inoperable display
Inoperable main control board
Loose wiring harness
E01 error code visible on display Relay shorted or open Call Tech Support 1-800-722-7853
E02 error code visible on display Conveyor 1 either jammed or not working Call Tech Support 1-800-722-7853
E03 error code visible on display Conveyor 2 either jammed or not working Call Tech Support 1-800-722-7853
E05 error code visible on display Set point temperature not reached in
expected time
Call Tech Support 1-800-722-7853
E06 error code visible on display Software files on USB not valid Call Tech Support 1-800-722-7853
E07 error code visible on display Transferred software files on external Flash
not valid
Call Tech Support 1-800-722-7853
E08 error code visible on display Temperature sensor open or shorted Call Tech Support 1-800-722-7853
E09 error code visible on display Current platen temperature 20

F higher
than set point temperature
Call Tech Support 1-800-722-7853
E10 error code visible on display
Current platen temperature 20

F lower than
set point temperature
Call Tech Support 1-800-722-7853
N1 notification visible on display Reminder to clean Clean unit and delete message.
NOTE: For all other problems, call approved local service agent.
Printed in USA
5/1/2022