Prince Castle 625-MFY, Руководство по эксплуатации

Страница: 6 / 17

2
A. Remove spatula.
B. Remove the top
plate by carefully
sliding it forward
and out of the unit.
C. Remove the venturi
plate.
Steamer 625-50 5 Rev G Printed in USA
1010 © 200 3 6
Steamer
625-M
FY
Cleaning - Daily PM Tasks
The following equipment is required:
• McD
®
All Purpose Super Concentrate (APSC)
• McD
®
Sink Pak Sanitizer McD
®
APC
(Australia only)
• McD
®
Delimer™ (as required)
• Clean sanitized towel
• Protective (insulated) gloves
Top Cover
Top Plate
Spatula
1
While wearing protective gloves, remove the top cover by
pulling up and off the unit.
3
A. Wash top cover, top plate, and venturi plate in a solution of
McD ® APSC / APC made up in the back sink.
B. Rinse with clean water, and then sanitize in a solution of
McD
®
Sink Pak Sanitizer.
C. Let air dry.
6
WARNING
Turn the unit off and unplug the power cord from the electrical recep-
tacle. Proceed with caution, unit is still hot!
CAUTION
This unit is not watertight. Do not clean with a water jet/jet spray. Do
not immerse the unit in water.
Do not use abrasive materials such as scrapers, steel wool, etc. to
clean the spatula or steam chamber.
4
Allow to sit for 5 minutes. Using
a clean sanitized towel, thoroughly
rinse and wipe the internal surfaces
5
Use brushes to clean the water tube. Dip the brush in warm water
or deliming solution. Insert the brush about 1" into water tube
and then remove. Repeat for 30 seconds.
While wearing protective gloves:
Wash all external surfaces of the steamer with a solution of
McD
®
APSC / APC. Using the McD
®
APSC / APC spray bottle,
spray directly onto a clean sanitized towel and wipe the unit
clean.
of the steam chamber. of the steam chamber.
Wipe the steam chamber surface with a clean sanitized cloth.
OPTIONAL: If the surface shows
signs of excessive calcium and
lime buildup, dissolve two tea-
spoons of McD
®
Delimer™ in a
small coffee cup with 100mI of
water. Pour half on each side.
Allow to sit for 5 minutes. Using
a clean sanitized towel, thoroughly
rinse and wipe the internal surfaces
buildup.
CAUTION
Do not spray directly on the unit or use abrasive cleaners!
Reassemble the unit.
Turn the unit on. When unit is preheated, run a minimum of
four cycles to prime the unit and remove any residual cleaner.
It is recommended that the steamers go through a deliming
procedure at least once a month. Some hard water areas may
require daily, weekly, or biweekly deliming based upon actual
Insert brush here.