Prince Castle 625-MFY, Руководство по эксплуатации

Страница: 9 / 17

TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE REMEDY
Unit will not heat up; “DISPLAY” Loose connections Check continuity wiring
is lit. On/Off switch is ON
Unit heats up but will not steam. Water supply is not connected Disconnect water line and check if water is flowing
Display reads “REMOVE” at end or shut off. Regulator has through main water supply. Check water pressure
of cycle. pressure set too low at regulator to ensure unit is receiving water.
Water delivery tube clogged Replace water tube
Defective main PC board or Call service technician
water solenoid
Water supply line is pinched Straighten water line
Unit steams continuously Defective main PC board or Call service technician
water solenoid
Unit is flooded Water pressure too high Turn input water regulator to between 20 and 30 PSI
Defective platen, water Call service technician
solenoid or relay
Bun temperature is too cold Water pressure too low Turn input water regulator to between 20 and 30 PSI
Not enough water CYCLES Check for proper programming of Filet steam cycles
Increase number of CYCLES until desired results are reached
Water ON cycle too short Check for proper programming of Filet steam cycles
Increase ON time until desired results are reached
Partially clogged water tube Clean/de-lime the water tube
Bun temperature is too hot Water pressure too high Turn input water regulator to between 20 and 30 PSI
Water ON cycle too long Check for proper programming of Filet steam cycles
Decrease ON time until desired results are reached
Too many water cycles Check for proper programming of Filet steam cycles
Decrease number of CYCLES until desired results are reached
Not enough moisture in bun Water pressure too low Turn input water regulator to between 20 and 30 PSI
Platen not hot enough Increase platen temperature
Water ON cycle too short Check for proper programming of Filet steam cycles
Increase ON time until desired results are reached
Not enough water CYCLES Check for proper programming of Filet steam cycles
Increase number of CYCLES until desired results are reached
Water OFF cycle is too short Check for proper programming of Filet steam cycles
Increase OFF time until desired results are reached
Partially clogged water tube Clean/de-lime water tube
Out of date buns Use fresh buns
Too much moisture in bun Water pressure too high Turn input water regulator to between 20 and 30 PSI
Water ON cycle too long Check for proper programming of Filet steam cycles
Decrease ON time until desired results are reached
Too many water CYCLES Check for proper programming of Filet steam cycles
Decrease number of CYCLES until desired results are reached
Water OFF too long Check for proper programming of Filet steam cycles
Decrease OFF time until desired results are reached
Water is leaking from behind the Water tube not properly Completely push tube into valve until you feel it click
unit pushed into valve
Faulty water valve Call service technician