Printed in USA 03/10 © 2010
12
247-500revH-EN
Toaster Grills
Models 247-ACC & 248-BCC
Adjusting Bun Crush Settings
To adjust the bun crush settings, use the knob located on the
front of the unit’s base. There are 10 incremental settings, each
increasing the center gap by approximately 2 mm.
(See
Figure 17
.)
• To set the thickness from 1 to 5, lift and slide the knob to the
left-most position. Then, rotate the knob until the desired
setting is in the “window”.
• To set the thickness from 6 to 10, lift and slide the knob to the
right-most position. Then, rotate the knob, until the desired
setting is in the “window”.
Figure 17
Adjusting for Bun Thickness
The 248-BCC model has two sets of notches in the side bun
fences. (See
Figure 18
.)
• Put the bun board in the front, lower notches for REG or QTR
buns.
• Use the rear, upper notches for MAC or RIB buns.
Figure 18
