INSTALLATION
1. After you have removed the sharpener from the
carton, inspect the unit for signs of damage. If there
is damage to the unit:
l
Notify carrier within 24 hours after delivery.
l
Save carton and packing materials for inspection
purposes.
l
Contact the Prince Castle Customer Sales
Department at 1-800-722-7853 to arrange for
a replacement to be sent.
2. Verify that all parts have been received.
3. Clean spatulas and scraper blades with soap and
water. Dry thoroughly before sharpening.
4. Assemble knob (item A in figure 1) to back frame of
sharpener.
IMPORTANT:
The knob can be assembled to either
side of back frame depending if operator is left or right
handed.
OPERATION
5. Turn carriage knob (item C in figure 1) counter-
clockwise to open jaws.
6. Lift carriage assembly (item B in figure 1) by large
knob (item C in figure 1) upward until it stops. Hold
in this position.
8. Press gauge stop bar (item D in figure 1) tab
downward until it makes contact with stop pin (item
E in figure 1).
9. Insert meat spatula or grill scraper blade squarely
against gauge stop bar (item D in figure 1).
IMPORTANT:
Center spatula in carriage.
10. Tighten jaws by turning carriage knob (item C in
figure 1) clockwise while holding carriage in the up
position.
11. Lift gauge bar (item D in figure 1) upward over
detent pin located on the side of the carriage. This
pin holds the gauge bar up.
12. Lower carriage assembly (item B in figure 1) with
tool to rest on the file.
13. While holding carriage knob (item C in figure 1) with
one hand and knob (item A in figure 1) with the
other, slide carriage back and forth on file, applying
moderate pressure. Continue until spatula has
good sharp edge.
14. Remove sharpened tool and burn from back side by
sliding along file.
15. Round corners by using a curve motion against the
edge of the file. Use the bar as a guide.
16. Wash tool, sanitize and dry.
CAUTION:
Handle tool carefully to avoid
getting cut.
TO SHARPEN REDI-GRIL BLADES
1. Place blade in special holder over pins with beveled
side up. See figure 2.
2. Hold blade with fingers and turn holder over.
3. Insert tool in carriage assembly against gauge
stop.
4. Repeat steps three through 13 under operation.
2
figure 1
B
D
E
A
C
figure 2
