TROUBLESHOOTING GUIDE
4
NON-SCHEDULED MAINTENANCE
Under normal conditions with proper use and cleaning,
very little non-scheduled maintenance is required for
this unit. However, this section provides procedures for
checking and replacement of the various parts used
within the cabinet in the event that it becomes neces-
sary. Before replacement of any parts, refer to the
troubleshooting guide above. This guide will assist in
determining the cause of any malfunction to insure
maintenance is required.
To change file or change to new position on existing
file:
A. Remove (2) screws. See item A in figure 3.
B. Turn file 180 degrees.
C. Tighten screws.
D. To use other positions of file, reverse file clamps.
See item B in figure 3.
figure 3
A
B
A
B
PROBLEM
Tool edge not
Tool not lined up properly in carriage
Reposition tool in carriage holder.
parallel.
against gauge stop.
File worn.
Reposition file to new surface.
IMPORTANT:
The file can be turned to four
positions.
PROBABLE CAUSE
CORRECTIVE ACTION
