
PROBLEMS & SOLUTIONS
40
PROBLEME & LÖSUNGEN
Problem: Brennstofflasche hält den Druck nicht, bzw. leckt
Grund: Rückschlagventil
der Pumpe
kaputt oder verschmutzt
Lösung:
➧
Pumpe
aus der Flasche schrauben, Rückschlagventil
(am
unteren Ende der Pumpe
in der Pumpe) herausnehmen, Gummidichtung
des Ventils säubern, wieder montieren
Problem: Man kann in der Brennstoffflasche keinen Druck
aufbauen
Grund: Lederdichtung
in der Pumpe
verschlissen oder trocken
Lösung:
➧
siehe Seite 32 „Lederdichtung in der Pumpe fetten“
Problem: Kocher faucht kurz und verlischt sofort wieder
Grund: zuviel Druck in der Flasche oder nicht genug vorgeheizt.
Lösung:
➧
etwas Druck ablassen (draußen, keine offene Flamme in der Nähe).
Mehr Vorheizung: (Seite 18).
Problem: Kocher faucht ab und zu oder „spotzt“
Grund: zuviel Druck in der Flasche oder nicht genug vorgeheizt, Mehr vor-
heizung: (seite 19).
Lösung:
➧
etwas Druck ablassen (draußen, keine offene Flamme in der Nähe)
Problem: Instabile gelbe Flamme
Grund: auch hier kann es mehrere Gründe geben: zuviel Druck in der Flasche
(
➧
s.o.), Düse
oder Brennstoffleitung
verstopft (
➧
siehe „Brennstoff-
leitung reinigen“, Seite 34).
Wenn Sie überhaupt nicht mehr weiterkommen und Ihr Primus Kocher sich
totstellt, sollten Sie sich an ihren Händler wenden. Ist kein Primus-Händler in
der Nähe, rufen Sie die nächste Primus-Vertretung an.
10
4
15
16
15
17
15
15
17
(on the lower end of pump
, inside the pump), clean rubber seal of valve,
and re-install.
Problem: you can not build up pressure in the fuel bottle
Reason: leather seal
in pump
is worn, ripped or dry
Solution:
➧
see page 33 “grease the leather seal in the pump”.
Problem: stove hisses briefly and goes out again
Reason: too much pressure in the bottle.
Solution:
➧
let out some of the pressure (outside, with no naked open flame
nearby).
Problem: stove hisses sometimes or “spits”
Reason: too much pressure in the bottle or not primed enough.
Solution:
➧
let out some of the pressure (outdoors, with no naked open flame
nearby). More priming: see page 19.
Problem: irregular yellow flame
Reason: there may here also be different reasons: too much pressure in the
bottle (
➧
see above), jet nipple
or fuel line
are blocked (
➧
see main-
tenance and cleaning, page 35).
If you can’t solve your problems and your Primus stove refuses to perform,
contact your dealer. If there is no Primus dealer at hand, call the Primus repre-
sentative.
10
4
15
16
15
Primus Manual RZ 1-10-04 14.39 Sida 40