Primula FLEX DOB, Инструкция по эксплуатации

Страница: 9 / 17

Instruction Manual
9
(approximately 5cm). After finishing ironing unhook the steam iron from the balancer and
put it on the iron rest mat.
* * In case your table disposes a blowing system of air:

Adjust the volume of the blowing air with the lever according to the requirements of
the fabric (weight, quality , etc.) from the knob which is placed in the main body of
the machine

Push with your foot pedal for using the blowing.
7. Maintenance

Make sure that the covers of the table and the ironing buck remain clean, in order to
have high performance of suction and blowing air. Wash the blue polyester fabric and
the foam blue once per week in the washing machine (30-40
ο
C).In case you use felt
molletone instead of blue foam, do not wash it in the washing machine, but wash it
on hand. Replace them regularly, in order to keep high suction and blowing
performance.

Clean the dust of the fan wheel /impeller at least 2-3 times per year.

Clean periodically and grease the arm’s as well as the buck’s bearings.

Clean periodically the internal parts of the table as well as the electronic circuit by
using compressed air.

Keep the machine clean.
CAUTION!
Before doing maintenance work, please disconnect the machine from the electrically power
supply.
8.
Troubleshooting
For the instructions mentioned in the current section please see the drawing of the spare
parts of the machine on page 11.
8.1
The vacuum does not function properly

Check if there is power supply.

Check if the power feeding cable is for some reason cut off.

Check the fuse 12Α which is inside the fusecase No 05.

Check if the suction’s bouton pedal No 09 is faulty.

Check if motor No 01 is for some reason damaged.

Check the relay No 13.

Check the electronic circuit Νο 18.
8.2 The heating of the working surface is not activated

Check if the fuse 12Α inside the fusecase No 05 is burnt out. Replace it.

Check if the safety thermostat No 31 is faulty. Replace it.

Check if the thermostat No 32 is faulty. Replace it.

Check if the heating element No 36 is burnt out. Replace it.

Check the power supply cable and power plug on the board surface (No 23).

Check if the switch No 76 is faulty. Replace it.
8.3 The heating of the ironing buck is not activated